When I run the ScreenLogic Connect software on my PC I get an error "System Not Found" I have a proper red light on the S2IPA so it is powered from the PL4 com port J20Ĥ.I have triple checked all wires and connections. ![]() My router assigns it a 10.x.x.x address through DHCP to the PC. I have previously tested this LAN connection with a PC (which is set to use DHCP just like the S2IPA supposedly defaults to use as well) and it connects to the network and internet just fine. ![]() The S2IPA is connected directly to my router by wired (CAT6) LAN RJ-45 cable and lights show I have a 10/100 connection on the router I have hardwired it correctly(J20 Com Port - 4 wires) to the ScreenLogic2 Interface Protocol Adapter (S2IPA).ģ. I have an Pentair EasyTouch PL4 control panel.Ģ.
0 Comments
Leave a Reply. |